kug-appc Page 46 Thursday, March 6, 1997 4:51 PM

E n v e l o p e F e e d e r

Removing the

Envelope Feeder

1 Power OFF the printer and disconnect both power cords and any interface cables.

2 Lift the Envelope Feeder up and out from the printer.

Store the Envelope Feeder in its original packaging materials, or in a dry, dust-free place.

3 Re-attach the face plate that was removed when the Envelope Feeder was installed.

4 Close the hinged clasp at the left side of the Front Tray.

Close the Front Tray if not needed.

5 Reconnect the power cord and interface cable(s) and power ON the printer.

After warming up for a few minutes, the Control Panel displays the following message:

Online

Ready

If any other message is displayed, see Table 6.2 starting on page 6-6.

C-46❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e