kug-appc Page 14 Thursday, March 6, 1997 4:51 PM

P o s t S c r i p t S I M M

4 Carefully pull out on the locking clips to release the PostScript SIMM.

5 Rotate the PostScript SIMM up to a vertical position, then lift it out.

6 Replace the controller board, sliding it along the alignment channels. Then hand-tighten the thumb screws.

7 Replace the power and interface cables and power ON the printer.

After warming up for a few minutes, the Control Panel displays the following message:

Online

Ready

If any other message is displayed, see Table 6.2 starting on page 6-6.

8 Press Online , then Reset and you see:

Reset Menu

Reset Printer

9 Press Downand you see:

Reset Menu

Reset Menus

C-14❖ L N 1 7 a n d L N 1 7 p s P r i n t e r s U s e r G u i d e