HP M1536dnf CE538ABGJ Load tray 1 Plain Size, Cleaning Page OK to start Manual duplex, Misprint

Control panel message	Description	Recommended action
Load tray 1 PLAIN <SIZE>	The product is performing a cleaning cycle.	Load the tray with plain paper of the size
alternates with		indicated. Press OK to start the cleaning
		cycle.
Cleaning Page [OK] to start
Manual duplex	The product is processing a manual duplex	To print the second side, place the pages
alternates with	job.	face down in the tray with the top edge first.
Load tray 1
Press [OK]
Manual feed <SIZE>, <TYPE>	The product is set for the manual feed	Load the tray with the correct size and type
alternates with	mode.	of paper, or press OK to use the paper that
		is in the tray.
Press [OK] for available media
Memory is low	The memory available for storing faxes is	Clear faxes from memory. Open the
Canceling recv.	insufficient for an incoming fax.	System Setup menu, and then open the
		Service menu. In the Fax Service menu,
		select the Clear Saved Faxs option.
		Turn off the Allow Reprint feature. When
		this feature is off, the product does not store
		received faxes in memory. Open the
		System Setup menu, and then open the
		Fax Setup menu. In the Advanced Setup
		menu, select the Allow Reprint option and
		turn it off.
Memory is low	The product does not have enough memory	If the product is processing other jobs, send
Press [OK]	to process the job.	the job again after those jobs have finished.
		If the problem continues, turn off the power
		by using the power switch, and then wait at
		least 30 seconds. Turn on the power and
		wait for the product to initialize.

Memory is low. Only 1 copy made. Press [OK] to continue.

Product memory is too low to complete this job.

Either copy fewer pages at a time or turn off collation.

If the error persists, turn the product off, and then turn it on.

Misprint	The product has experienced an internal
Press [OK]	hardware error.

1.Reprint the pages.

2.If the error persists, turn the product off, and then turn it on.

3.Print the pages again.

4.If the error persists, clean the rollers in the paper pick assembly, the duplexer door, and the duplexer frame.

ENWW Tools for troubleshooting 137