Integrating SAP R/3 and Data Protector

Data Protector SAP R/3 Configuration File

[-sub[list]<sublist_name>] specifies the sublist in the configuration file to which a parameter is written to or taken from.

[-local<filename>] specifies one of the following:

•When it is used with the -getconf[ig]option, it specifies the filename for the output of the command to be written to. If the -localoption is not specified, the output is written to the standard output.

•When it is used with the -getopt[ion], it specifies the filename of the file from which the parameter and its value are to be taken and then written to the standard output. If the -localoption is not specified, the parameter and its value are taken from the Data Protector SAP R/3 configuration file and then written to the standard output.

•When it is used with the -putopt[ion]option, it specifies the filename for the output of the command to be written to. If the -localoption is not specified, the output is written to the Data Protector SAP R/3 configuration file.

NOTE

If you are setting the option_value parameter as a number, the number

 

must be put in single quotes, surrounded by double quotes.

 

 

Return Values The util_cmd command displays a short status message after each operation (writes it to the standard error):

•Configuration read/write operation successful.

This message is displayed when all the requested operations have been completed successfully.

•Configuration option/file not found.

This message is displayed when either an option with the specified name does not exist in the configuration, or the file specified as the -localparameter does not exist.

•Configuration read/write operation failed.

This message is displayed if any fatal errors occurred, for example: the Cell Manager is unavailable, the Data Protector SAP R/3 configuration file is missing on the Cell Manager, etc.

162

Chapter 2