HP UX 11i v1 I/O Cards manual Data.setport.portno, Data.setport.rcode, Data.setport.spare

ZCOM C I/F Library Routines

ZCONFIG (3X)

Configuration Data

header.config

ZCOM_ZCONFIG_PORT (port configuration)

header.action
ZcDSC_ALL_PARMS	(1)	- Set all operating modes
		(Configuration, Baud Rate and
	Port)
ZcDSC_CFG_MODE	(2)	- Set Configuration mode only
		(Ecode, Sync, Mode, Parity)
ZcDSC_BAUD_RATE	(3)	- Set Baud Rate mode only
		(X.Clk, S.Clk, Baud Rate)
ZcDSC_PORT_MODE	(4)	- Set Port mode only (Pmode)
ZcDSC_BREAK_REQ	(5)	- Port Break request
ZcDSC_SET_XMIT_LIMIT	(6)	- Modify port transmit limit
ZcDSC_ENABLE_PORT	(7)	- Enable a port
ZcDSC_DISABLE_PORT	(8)	- Disable a port

header.tag1,

header.tag2 Any values.

data.setport.iftno

Interface card number (0, 1,...).

data.setport.portno

Port number in the interface card:

0..7 For Z7200A, Z7340A, and Z7400A ACC interface cards 0..3 For the Z7300A ACC interface card

0..1 For the Z7350A ACC interface card

data.setport.rcode

This field is for actions 1-4 only. Values are: 1 - Use configuration in interface table

2 - Use data in field \fIdata.setport.cnfg

data.setport.spare

Unused spare field. For data alignment.

190 Chapter 4