HP UX 11i v1 I/O Cards manual Data.setportsc.ptcfg-ptinfo.subchb.spec, Set to Mode

ZCOM C I/F Library Routines

ZCONFIG (3X)

data.setportsc.ptcfg->ptinfo.subchb.spec[ ]

Subchannel specification data: used for actions ZcDSC_ALL_PARMS or ZcDSC_SET_SUBC_SPECS only. Up to 32 subchannel specifications are allowed. For action ZcDSC_ALL_PARMS, all subchannels are configured. For action ZcDSC_SET_SUBC_SPECS only subchannel entries with the UPD bit set are configured. The subchannel specification definition is shown below:

15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
0	UPD			ITBS							Set to 0
		Set to 0					0	INV		Set to 0			Mode		0

UPD: The Update bit is used with the ZcDSC_SET_SUBC_SPECS action to identify subchannels which are to be configured. Subchannels with the UPD bit not set, are unaffected by the ZcDSC_SET_SUBC_SPECS action.

ITBS: Individual Transmit Buffer Size specifies the part of the on-chip transmit buffer allocated to the subchannel. The buffer is 64 bytes long and each timeslot assigned to the subchannel uses two bytes. For example, in the case of a subchannel that uses three timeslots (3 x 64Kbps = 192Kbps), the ITBS value should be set to six (6).

INV: Inversion; if this bit is set, all data of the subchannel transmitted or received by the MUNICH32 is inverted.

Mode: Defines the transmission mode: 00 - Transparent Mode A

01 - Transparent Mode B or Transparent Mode R

10 - V.110/X.30 Mode

11 - HDLC Mode

data.setportsc.len

The length in bytes of the subchannel buffer. For actions ZcDSC_ALL_PARMS, ZcDSC_SET_TIMESLOTS and ZcDSC_SET_SUBC_SPECS this length parameter should be set to the size of the data.setportsc.ptcfg->ptinfo.subchbstructure (e.g. “sizeof(subchbuf_def)”). For all other actions this length is zero.

data.setportsc.qlimit

New port limit (in bytes). This field is for action ZcDSC_SET_XMIT_LIMIT only.

Chapter 4 201