HP UX 11i v1 I/O Cards manual Table entry from which you want the shared receivers list

	ZCOM C I/F Library Routines
	ZGET_SHRCVR_LIST (3X)
fork unsafe	It cannot be called by a child process after fork(2)
	but before exec(2).
	See the NOTES section below for more information
	on using this routine in a multi-threaded application.

PARAMETERS	zap	ZCOM address pointer. The uses of node, zlu and zcs depend on the
		specified mode. But in general this is used to select the specific
		table entry from which you want the shared receivers list.
	mode	Specifies which shared receiver list to return.
		0 - Logical Terminal Table Shared Receivers (zap->zluis the ZLU
		of a terminal entry in the LTT, node and zcs are not used)
		1 - Physical Terminal Table Shared Receivers for “normal” data and
		Status messages (zap->zluis the ZLU of an entry in the PTT).
		2 - Physical Terminal Table Shared Receivers for “control”
		messages (zap->zluis the ZLU of a terminal in the PTT).
		3 - DSC Event Receivers (The zap parameter is not used)
		4 - Node Status Event Receivers (zap->nodeis the required node
		number, zcs and zlu are not used)
	mlen	Maximum number of receivers to be returned in the zrcvrs array. To
		get the full list of receivers, this should be
		ZcMAX_SHARED_RCVRS+1.
	zrcvrs	This is a returned array of all shared receivers currently configured.
	(Return	Each entry in the array is a single receiver for the type of data
	Param)	specified by the mode parameter. The list is terminated by an entry
		with a zlu value of 0. The maximum number of receivers in each
		type of shared receiver list is set to ZcMAX_SHARED_RCVRS
		(currently, 64). Hence, to get the full list of receivers, this array
		should have ZcMAX_SHARED_RCVRS+1 entries.

Chapter 4 215