starting position. It then scans the document. The resulting image is electronically sent to the Printer and your copy is printed.
NOTE: If AUTOSCAN is disabled, you will need to press the Start key to begin the scan. Refer to "Controlling the scan" on the previous page.
NOTE: If the PRODUCTIVITY mode is enabled the document will start scanning immediately. If the PRODUCTIVITY mode is not enabled, the document will
3.When the document is returned to the READY position, do one of the following:
∙Pull the document to remove it. Lift the Thick Document Lever to remove fragile or thick documents.
∙Press the Start key on the Scanner Control Panel to scan the document again.
NOTE: If DOCUMENT RETURN is set to REAR, the document is delivered to the rear Stacker. Some documents exit to the rear Stacker regardless of the DOCUMENT RETURN setting. Refer to "Controlling the scan" on the previous page.
Making a copy the same size as the original document
1.Set the Media Selection Source to Auto. The Auto indicator lamp illuminates. This setting allows the WIDE FORMAT COPY SYSTEM to automatically select the available media roll that best fits the image width.
NOTE: If the correct media size is not loaded, the next larger size will be used.
2.Select the Media Selection, Type. The default setting is Bond.
3.Set the Media Selection, Output Format to Synchro. This setting cuts the media to the same length as the original document.
4.Set Reduce/Enlarge to Preset. If the size is not already set to 100%, use the Previous and Next keys to select a reduction and press the Enter key.
5.Insert the document face down into the Scanner. If the scan does not start automatically, press the Start key.
NOTE: To set the scan to begin automatically, refer to "Scanner Control" in the "Main Menu" section.
NOTE: If the image needs to be rotated to fit on the selected media size, additional processing time is required. If possible, feed the original
XEROX WIDE FORMAT COPY SYSTEM | Making copies ∙ 51 |