IBM T400F manual 22h

TapeAlert Flags Supported by the IBM TotalStorage LTO Ultrium 2 Tape Drive

Flag	Flag
	Parameter	Flag	Description	Action Required
Number
	(in hex)
34	22h	Download fail	Set when an FMR image is	Ensure that it is the correct
			unsuccessfully downloaded to	image. Download the FMR
			the tape drive via the SCSI or	image again.
			Fibre Channel interface.
36	24h	Drive temperature	Set when the drive’s temperature	See error code 1 in Table 15 on
			sensor indicates that the drive’s	page 67.
			temperature is exceeding the
			recommended temperature of the
			enclosure (see Table 4 on
			page 11).
37	25h	Drive voltage	Set when the drive detects that	See error code 2 in Table 15 on
			the externally supplied voltages	page 67.
			are either approaching the
			specified voltage limits or are
			outside the voltage limits (see
			Table 4 on page 11).
39	27h	Diagnostics required	Set when the drive detects a	See error code 6 in Table 15 on
			failure that requires diagnostics	page 67.
			to isolate the problem.
51	33h	Tape directory invalid	Set when the tape directory on	Rebuild the tape directory by
		at unload	the tape cartridge that was	reading all the data
			previously unloaded is corrupted.
			The file-search performance is
			degraded.
52	34h	Tape system area	Set when the tape cartridge that	Copy the data to another tape
		write failure	was previously unloaded could	cartridge, then discard the old
			not write its system area	cartridge.
			successfully.
53	35h	Tape system area	Set when the tape system area	Copy the data to another tape
		read failure	could not be read successfully at	cartridge, then discard the old
			load time.	cartridge.

Appendix B. TapeAlert Flags 99