Fixing an Internal Jam
Attention:
This procedure must be performed only by trained service personnel.
If
Before performing this procedure, ensure that you have completed the steps that begin on page 86. Do not attempt this procedure until you have completed these steps.
If you have reached this point, the tape is broken or the leader pin dropped (or looked like it dropped) from the leader block. To fix these conditions, perform the following procedure.
1.If the drive is mounted in an enclosure, perform the procedure to remove it (see “Removing a SCSI Tape Drive from an Enclosure” on page 83 or “Removing a Fibre Channel Tape Drive from an Enclosure” on page 84).
2.Place the drive on a nonslip surface.
3.Remove the cover of the drive by performing the following steps:
a. Use an appropriate tool to remove the three screws and washers (see
in Figure 31 on page 89) that secure the bezel . Remove the bezel.
b.Use a screwdriver to remove the four
.
c.Remove the cover by lifting it up. Set the cover aside.
