A P P E N D I X Intel® NetStructure™ 470T and 470F Switches User Guide
Regulatory Information
FCC Part 15 Compliance Statement
This product has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
This product generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning this equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
·Change the direction of the radio or TV antenna.
·To the extent possible, relocate the radio, TV, or other receiver away from the product.
·Plug the product into a different electrical outlet so that the product and the receiver are on different branch circuits.
If these suggestions don’t help, consult your dealer or an experienced radio/TV repair technician for more suggestions.
NOTE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CAUTION If you make any modification to the equipment not expressly approved by Intel, you could void your authority to operate the equipment.
Canada Compliance Statement (Industry Canada)
Cet appareil numérique respecte les limites bruits radioélectriques applicables aux appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”,
édictée par le Ministre Canadien des Communications.
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the
Communications.
Manufacturer Declaration
This certifies that the Intel® NetStructure 470T and 470F Switches comply with the EU Directive 89/336/EEC, using the EMC standards EN55022 (Class A) and EN55024. This product also meets or exceeds EN 60950 (safety) requirements. These products have been tested and verified to meet CISPR 22 Class A requirements.
Australia Statement
Taiwan Class A EMI Statement
VCCI Statement
Class A ITE
This is a Class A product based on the standard of the Voluntary Control Council for Interference by Information Technology Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions.
Warnings
WARNING
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures.
Internal access to Intel® NetStructure 470T and 470F Switches intended only for qualified service personnel. Do not remove any covers.
WARNING
The system is designed to operate in a typical office environment. Choose a site that is:
·Clean and free of airborne particles (other than normal room dust).
·Well ventilated and away from sources of heat including direct sunlight.
·Away from sources of vibration or physical shock.
·Isolated from strong electromagnetic fields produced by electrical devices.
·In regions that are susceptible to electrical storms, we recommend you plug your system into a surge suppressor and disconnect telecommunication lines to your modem during an electrical storm.
·Provided with a properly grounded wall outlet.
Do not attempt to modify or use the supplied AC power cord if it is not the exact type required.
Ensure that the system is disconnected from its power source and from all telecommunications links, networks, or modems lines whenever the chassis cover is to be removed. Do not operate the system with the cover removed.
130
