A P P E N D I X Technical Information

####Configure a Protocol Based VLAN ############################################

#

# proto_vlan_list={(Vlan,Proto,MemberPort,MemberPort...)(Vlan,Proto,MemberPort)...}

# Vlan=Name of VLAN

# Proto=Name of Protocol (IP, IPX, NETBUI)

# MemberPort=Number of member port(s)

#

proto_vlan_List{“IPVLAN”,”IP”,1,3,5,7)(“IPXVLAN”,”IPX”,2,4)}

###### Create 802.1Q VLAN on the Switch (Static Entries) ###################################

#

#802_1q_static_list={(VID, “VLANstring”, M/N U/T,...) (VID, “VLANstring”, M/N U/T,...)}

#M=member port (on ingress)

#N=non-member port (on ingress)

#U=untagged device (on egress)

#T=tagged device (on egress)

#Either M or N can be specified for each port; not both

#Either U or T can be specified for each port; not both

#

802_1q_static_list={(2, “VLAN2”, MT, MU, MT, NT, MT, NU, NT, NU) (10, “VLAN10”, MT, MU, NT, NT, MT, MU, NT, MU)}

###### GVRP (Dynamic VLAN Registration) ###################################

#

#gvrp_enabled={port#, port#, ...}

#gvrp_disabled={port#, port#, ...}

#gvrp_enabled=VLAN dynamically registered with the switch

#gvrp_disabled=VLAN not dynamically registered with the switch

gvrp_enabled={1, 3, 5, 7} gvrp_disabled={2, 4, 6, 8}

###### Configure Port Mirroring based on source/destination MAD address ################

#

#mirr_list={srcport,targport,(srcaddr,dstaddr)(srcaddr,dstaddr)...}

#srcport=The Source Port for the mirror

#targport=The Target Port to which packets will be mirrored

#srcaddr=Source MAC Address or “any”

#dstaddr=Destination MAC Address or “any”

#

mirr_list={1,5(00-01-63-22-e0-00,“any”) (“any”,00-01-63-22-e0-00)

(00-01-63-22-e0-01,00-01-63-22-e0-02)} mirr_list={2,6(any,any)}

Appendix

123

Page 129
Image 129
Intel 470 manual 123