Intel SDS2 - page 129

Errata Listing Intel® Server Board SDS2
Revision 1.2
Order Number: A85874-002
118
Implication: If you are installing the Intel Server Board SDS2 into the Intel SC5100 Server
Chassis, Intel recommends installing the rubber bumper included with the
server board. If you are installing the Intel Server Board SDS2 into a chassis
other than the Intel SC5100 Server Chassis, compare the rubber bumper height
to the chassi standoff height. If the bumper is the same height as the standoffs
in the chasis, install the rubber bumper included with the SDS2 Server Board. If
the suport is not the same height, procure a bumper that matches the height of
the standoffs used in your chassis. The rubber bumper should be installed on
the chassis as follows:
For the Intel SC5100 chassis:
1.Remove the backing from one of the rubber bumpers included with your
chassis.
2.Press the rubber bumper firmly into place approximately ½ inch (2 cm) to the
right of the chassis baseboard hole marked “9.” See location A below.
For other chassis:
1.Remove the backing from one of the rubber bumpers included with your
chassis.
2.Locate the chassis standoff labeled “1” in your chassis.
3.Place the rubber bumper at a location 6.25 inches (16 cm) toward the front of
the chassis and 7.75 inches (19 cm) toward the center of the chassis from
standoff 1. See location B below.
4.Press the rubber firmly into place.