
Intel® Server Board SDS2 | I/O Subsystem |
4.I/O Subsystem
4.1PCI Subsystem
The primary I/O bus for SDS2 DP Server Board is PCI, with three PCI bus segments. The PCI buses comply with the PCI Local Bus Specification, Rev 2.2. The
Table 4. PCI Bus Segment Characteristics
PCI Bus Segment | Voltage | Width | Speed | Type | PCI Slots |
|
|
|
|
|
|
5 V | Peer Bus | Slots 3 and 4 – Full Length | |||
|
|
|
|
|
|
3.3 V | Peer Bus | Slots 1 and 2 – Full Length | |||
|
|
|
|
|
|
3.3 V | Peer Bus | Slots 5 and 6 – Full Length | |||
|
|
|
|
|
|
Note: When an
4.1.132-bit, 33-MHz PCI Subsystem
All
∙2D/3D Graphics Accelerator: ATI RAGE XL Video Controller
∙Two Network Interface Controller: Intel 82550 Fast Ethernet Controller
∙PCI Slots 3 and 4
∙CSB5 South Bridge
Each of the embedded devices above, except for the CSB5 South Bridge, is allocated a GPIO to disable the device.
4.1.1.1Device IDs (IDSEL)
Each device under the PCI hub bridge has its IDSEL signal connected to one bit of AD [31:16], which acts as a chip select on the PCI bus segment in configuration cycles. This determines a unique PCI device ID value for use in configuration cycles. The following table shows the bit to which each IDSEL signal is attached for
Revision 1.2 | 11 |
Order Number: |