Intel® Server Board SDS2 | BIOS |
6.3.3CMOS Memory Definition
The CMOS map is available in the NVRAM.LST file generated for every BIOS release. The CMOS map is subject to change without notice.
6.3.4Clearing CMOS
The BIOS detects the state of the CMOS jumper. If the jumper is set to “CMOS Clear” prior to
Password settings are unaffected through CMOS clear. The BIOS clears the ESCD parameter block and loads a null ESCD image. The boot order information is also cleared when CMOS is cleared via jumper. The configuration data for the
If the Reset Configuration Data option is enabled in Setup, ESCD data and BIOS Boot specification data is cleared and reinitialized in next boot.
6.4Flash Update Utility
Note: The Phoenix* PHLASH utility must be run without the presence of a 386 protected mode control program, such as Microsoft* Windows* NT* / 2000 or EMM386*. Phoenix* PHLASH uses the processor’s flat addressing mode to update the flash ROM.
6.4.1Loading the System BIOS
The BIOS update utility (PHLASH) loads a new copy of the BIOS into Flash ROM. The loaded code and data include the following:
∙
∙BIOS Setup Utility
∙Quiet Boot Logo Area
When running PHLASH in interactive mode, the user may choose to update a particular Flash area. Updating a flash area takes a file or series of files from a hard or floppy disk, and loads it in the specified area of Flash ROM.
To manually load a portion of the BIOS, the user must specify which data file(s) to load. The choices include PLATCBLU.BIN, PLATCXLU.BIN, PLATCXXX.BIN, PLATCXLX.BIN or PLATCXXU.BIN. The last three letters specify the functions to perform during the flash process:
C = Rewrite BIOS
B = Rewrite Boot block
L = Clear LOGO area
U = Clear user binary
X = place hold
Revision 1.2 | 67 |
Order Number: |