Intel SDS2 manual Revision Order Number A85874-002

Errata Listing Intel® Server Board SDS2

28.OB P100 NICs do not show at POST but attempt PXE boot and appear in Boot Menu

Problem:	On board NIC are not displayed during post but do appear in Boot Device menu.
	These controllers will also attempt to do a PXE boot if no other bootable devices
	are found.
Implication:	Not all boot devices displayed during POST when diagnostic display is enabled.
Workaround:	None. This is by design. The system BIOS builds the on-board network
	controller Option ROM with an option that always makes the OPROM “quiet”. It
	therefore does not display any text messages and does not allowing the CTRL-
	S option.
Status:	Will not fix.

29.Dodson: Adaptec 39160 in slots 5 & 6 causes Expansion ROM error

Problem:	Add in Adaptec 39160 Ultra 160 controller installed in slots 5 & 6 causes an
	Expansion ROM error after last system POST. No other adapters are present.
Implication:	Error message: Expansion ROM not initialized - PCI Mass Storage controller in
	slot 06. Bus: 02, Device: 09, Function: 01
Workaround:	Adaptec's single image Option ROM requires one 'master' controlling channel
	that is set using the <Ctrl-A> SCSI Select utility. Each channel loads the Option
	ROM, determines whether it is the 'master' channel, and if not it unloads
	completely. If it is the 'master', it proceeds to scan all devices and list all
	possible drives. Only one channel does this scanning, but ALL channels load
	the Option ROM initially if the Option ROM is enabled on the slot.
	The error is coming from the second channel on the Adaptec 39160, even
	though the first channel has already completed the 'master' scan. The reason it
	is only happening in Slots 5 and 6 and when the NIC Option ROMs are all
	loaded is because that is when the available Option ROM space is at a
	minimum. The NIC Option ROM's are small, but apparently they make enough
	difference. The onboard 7899 Option ROM loads after Slots 1-4, but before
	Slots 5 & 6.
	The solution here is to enable channel B of the ASC39160 as the 'master'
	channel. When this is done, channel A loads the Option ROM, sees that it is not
	the 'master', and unloads. Then channel B loads the Option ROM, does the full
	scan of all devices, and remains in memory. At this point no other channels are
	found, so no other devices error. The key here is that the LAST available
	Adaptec channel should be listed as the Master - unfortunately, this is opposite
	from their default - they default to the first available channel.
122	Revision 1.2
	Order Number: A85874-002