Chapter 9: Setting up Firmware and Hardware
The firmware status is represented by a general LED color for the firmware and individual LEDs for each protocol, as follows.
| LED Color | General Firmware | Protocol LEDs |
|
|
|
Red | No firmware file for the selected card | N/A |
| is found on the hard disk. (The |
|
| firmware list is empty.) |
|
| This is typically the case for a newly |
|
| added adapter before the WAN setup is |
|
| applied (with the Apply button). |
|
|
|
|
Gray | Firmware is found on the hard disk but | The protocol layer |
| is not loaded into the card. (The | is inactive. |
| firmware list is empty.) |
|
| Either no WAN adapter is installed, or |
|
| the selected adapter is not running. |
|
|
|
|
Yellow | Firmware is running on the card, but | Changes to the |
| differs from the firmware on the hard | firmware layer have |
| disk for this card. | been applied, but |
| The firmware on the disk has been | have not been |
| updated but not loaded onto the | loaded and saved to |
| adapter. Although the firmware list | the disk. |
| displays updated firmware, older |
|
| firmware is running on the adapter. |
|
|
|
|
Green | The firmware is running. | The protocol layer |
|
| is active. |
|
|
|
| Use the following buttons to set up firmware information. | |
|
|
|
| Click... |
| To do this... |
|
|
|
| Load |
| Download the current firmware to the selected adapter. |
|
| CAUTION: This option disconnects all connected |
|
| channels and resets the SNA link services. |
|
|
|
iSPAN Serial WAN Adapter Users Guide | 149 |