Janome 1100D Professional SECTION Machine Set-up, Attaching the Thread Guide Pole, Thread cones

1

2

e

3

SECTION II

Machine Set-up

Attaching the Thread Guide Pole

1. Insert the thread guide pole into the spool pin base located at the back of the machine. Make sure the slot of the thread guide pole grips the rib in the base hole.

2. Pull the thread guide pole to its highest position. Align the thread guide portion with the spool pins.

w

Placing the Foam Pads and Spool Holders

Remove the spool holders. Place the foam pads and the spool holders. The foam pads help stabilize the spools of thread.

Both thread cones and spools of thread can be used.

q

		q Foam pad
		w Spool holder
	1.	Thread cones
	For thread cones, use the spool holders. Place the
	thread cone on the spool holder and push the cone as
	far as it will go.
	2.	Spools of thread
e
	For spools of thread, remove the spool holder. Place
	the spool of thread on the spool pin and attach the
	spool cap.
		e Spool cap
	3.	Spools of decorative thread (specialty threads)
	Place the spool directly on the foam pad to prevent the
	thread from slipping underneath the spool.

14