TROUBLESHOOTING
SKIPPING OR IRREGULAR STITCHES |
|
Incorrect threading | |
Incorrect thread tensions | |
Needle problems | 12 |
Needles not inserted correctly | 24 |
Do not pull on fabric, guide it gently | 48 |
Needle plate or foot not attached correctly | 66 |
Cutting width dial not set correctly | 26 |
Thread guide pole not extended/positioned correctly | 14 |
Do not lift presser foot at end of seam | 48 |
Incorrect pressure used for heavier fabrics | 46 |
THREAD BREAKS |
|
Incorrect threading | |
Incorrect thread tensions | |
Thread tangled or knotted | 30 |
When |
|
unthreaded before | 52 |
Needle plate or foot not attached correctly | 66 |
Thread guide pole not extended/positioned correctly | 14 |
Use the foam pads to avoid thread tangling | 14 |
FABRIC PUCKERS |
|
Needle tension(s) too high | |
Stitch length too long | 62 |
Foot pressure not set correctly for fabric | 46 |
Needle plate or foot not attached correctly | 66 |
Differential feed not set correctly for fabric | 60 |
NEEDLE BREAKS |
|
Needle strikes foot or needle plate since fabric is pulled; |
|
do not pull fabric, gently guide it | 48 |
Needle problems – poor quality, bent or dull | 12 |
Needle(s) not inserted correctly | 24 |
Needle size incorrect for fabric | 12 |
MACHINE JAMS |
|
Incorrect threading | |
Needle plate not attached correctly | 66 |
Stitch length too short | 22, 62 |
Incorrect thread tensions | |
Needle thread not engaged properly in |
|
tension discs; use tension release lever | 42, 54 |
Thread tangled or knotted | 30 |
Foot pressure set too low | 46 |
Use the foam pads to avoid thread tangling | 14 |
Upper knife is disengaged and |
|
fabric edge is too far to right; needles can break | 26 |
MACHINE RUNS SLOW OR NOT AT ALL |
|
Reconnect foot control | 16 |
Cleaning and oiling | 66 |
NOISY MACHINE |
|
Cleaning and oiling | 66 |
Clean both upper and lower knives | 66 |
Replace bent or dull needle(s) | 12 |
Replace upper knife | 68 |
FABRIC IS NOT CUT |
|
Upper knife not engaged correctly | 26 |
Upper knife not attached correctly | 68 |
Check if upper knife is locked correctly | 62 |
FABRIC NOT CUT CORRECTLY |
|
Cutting width dial not set correctly | 26 |
Upper knife not attached correctly | 68 |
Clean both upper and lower knives | 66 |
Check if upper knife is locked correctly | 62 |
Lock upper knife when sewing heavyweight fabric | 62 |
Unlock upper knife when not sewing heavyweight fabric | 62 |
Replace upper knife | 68 |
Check needle plate setting knob position | 28 |
STITCHES ARE NOT FORMED CORRECTLY ALONG FABRIC
EDGE |
|
Wrong program number is selected | 20 |
Recheck all threading points | |
Cutting width dial not set correctly | 26 |
Check needle plate setting knob position | 28 |
Thread tension(s) too high or too low |
70