JBL SDP-40HD manual Front L/R

SDP-40HD Setup

SETTING CROSSOVER POINTS (continued)

FRONT L/R (continued)

SETUP SPEAKERS SYNTHESIS 7CH FRONT L/R

When a SYNTHESIS 7CH speaker setup is selected, an 80Hz crossover point is applied to the FRONT L/R output connectors, and the FRONT L/R parameter cannot be adjusted.

CENTER FULL, FULL + SUB, 30Hz to 120Hz, THX 80Hz, NONE

SETUP SPEAKERS CUSTOM SETUP CENTER

Opens the CENTER SPEAKER menu to select a crossover point for the CENTER output connector.

•Select FULL to send a full-range signal to the center speaker. Otherwise, select the crossover point closest to the low frequency rating of the center speaker.

•Select FULL + SUB to send a full-range signal to the center speaker and duplicate bass frequencies to the SUB L/R outputs. (The set crossover point of the SUB XOVER parameter determines the upper range of duplicate bass.) Selecting the FULL + SUB option can result in excessive bass.

•Select NONE when the speaker setup does not include a center speaker. The SDP-40HD then redirects center channel signals to the Front L/R output connectors – unless the 5.1mc BYPASS listening mode is activated. In this case, configure the speaker setup with the associated DVD-A/SACD player to redirect center channel signals.

SETUP SPEAKERS SYNTHESIS 7CH CENTER

When a SYNTHESIS 7CH speaker setup is selected, an 80Hz crossover point is applied to the Center output connector, and the CENTER parameter cannot be adjusted.

SIDE L/R FULL, FULL + SUB, 30Hz to 120Hz, THX 80Hz, NONE

SETUP SPEAKERS CUSTOM SETUP SIDE L/R

Assigns a crossover point for the Main Zone audio output connector labeled SIDE L/R when a custom speaker setup is selected. Opens the SIDE L/R SPEAKERS menu to select a crossover point for the SIDE L/R output connectors.

•Select FULL to send a full-range signal to the side speakers. Otherwise, select the crossover point closest to the low frequency rating of the side speakers.

•Select FULL + SUB to send a full-range signal to the side speakers and duplicate bass frequencies to the SUB L/R outputs. (The set crossover point of the SUB XOVER parameter determines the upper range of duplicate bass.) Selecting the FULL + SUB option can result in excessive bass.

•Select NONE when the speaker setup does not include side speakers. The SDP-40HD will redirect side channel signals to the Rear L/R output connectors. If the REAR L/R parameter is also set to NONE, the SDP-40HD will redirect surround channel signals to the Front L/R output connectors.

Note:

When the SIDE L/R parameter is set to NONE, Dolby Digital SurroundEX, THX Ultra2, THX Surround EX, DTS(-ES) decoding, the ASA parameter, and PLIIx modes are not available.

SETUP SPEAKERS SYNTHESIS 7CH

When a SYNTHESIS 7CH speaker setup is selected, an 80Hz crossover point is applied to the SIDE L/R output connectors, and the SIDE L/R parameter cannot be adjusted.

3-33