JVC DR-M7S manual PDC Recording, Enter the recording stop time, Enter the channel position

Filename [DR-M7EK_08Recording.fm]
DR-M7EK_01.book Page 59 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

59

F Enter the recording stop time.

Press w e to select “STOP”, then press rt repeatedly to set the desired stop time.

●Each press of rt advances/goes back the stop time in 1-min. increments.

●To advance/go back the stop time in 30-min. increments, press and hold rt.

G Enter the channel position.

Press w e to select “TV PROG”, then press rt repeatedly to select the desired channel.

H Set the other recording options as required.

Refer to step E in “VIDEO Plus+® Timer Programming” ( pg. 56).

I Access the confirmation screen.

Press ENTER.

J Complete timer programming.

Press ENTER.

●To programme another timer, repeat steps B – J.

K Engage the unit’s timer mode.

Press # (TIMER). The unit turns off automatically and “#” appears on the front display panel.

●To disengage the timer mode, press # (TIMER) again.

NOTES:

●The beginning of a programme may not be recorded. Also, if the 1st programme’s recording stop time and the 2nd programme’s recording start time is the same, the ending of the 1st programme may not be recorded.

●If the copy limited programme is received during timer- recording, the unit enters Record Pause mode. Recording starts again if it is switched to a recordable broadcast during the time you programmed.

Satellite Receiver Users

To timer-record a satellite broadcast using Manual Timer Programming:

APerform “Satellite Receiver Control Setting” on page 28. B Perform “Manual Timer Programming”. In step G, press AUX to change “TV PROG” to “SAT”. Then press rt to

enter the channel position for the satellite broadcast. In step H, you cannot set “VPS/PDC” to “ON”.

C Leave the satellite receiver’s power on.

PDC Recording

Now available from some TV stations, PDC (Programme Delivery Control) is a service designed to assure safe, accurate timer recording. With this system, special code signals are transmitted together with the audio/video signals. These code signals control your unit and have precedence over the advertised times which you may have preset into the timer. This means that your unit will start and stop recording when the preset TV programmes actually start and end — even if the broadcast time of a preset TV programme is changed from what has been advertised. PDC is currently available nationally on BBC1, BBC2, Ch.4 and Ch.5, except from a few small relay transmitters. Ch.3 operates a PDC service in some areas. All channels intend to offer this service in due course. Check your TV programme listing guide for latest information. If the channel you intend to record does not offer a PDC service your unit will not start recording if PDC has been selected. Be sure to set PDC to “OFF” if PDC is not available on your selected channel. (See step H on page 59.)

NOTES:

●When you use Manual Timer Programming, set the start time (PDC time) exactly as advertised in the TV listing. A different time than advertised will result in no recording.

●PDC recording is also possible when a satellite receiver or a cable system is connected to L-2 IN/DECODER connector on your unit.

●PDC recording is also possible via the L-1 IN/OUT connector.

Page 59

April 2, 2004 11:21 am