JVC DR-M7S To turn off superimposed indications, Seconds just after the corresponding operation

Filename [DR-M7EK_11Subsidiary.fm]
DR-M7EK_01.book Page 93 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

93

DISPLAY SET

(The boldface settings in the table below indicate the settings at your purchase.)

8 SUPERIMPOSE	You can select the modes of indications superimposed on the TV screen.
OFF	OFF:
AUTO	To turn off superimposed indications.
	AUTO:
	To superimpose operational indications for approximately five
	seconds just after the corresponding operation.

	NOTES:
	● When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE”
	to “OFF” before starting. ( pg. 81, “Edit To Or From Another Recorder”)
	● When you select “AUTO”, during playback, the operation mode indicators may be
	disturbed depending on the type of disc being used.
8 GREY BACK	When this function is set to “ON”, the TV screen becomes all grey when
OFF	receiving a channel not in use.
ON	NOTE:
	When you want to receive an unstable channel with poor signals, set this function to
	“OFF”.
8 DIMMER	You can change the brightness of the front display panel.
BRIGHT	BRIGHT:
DIMMED1	Normally select this.
DIMMED2	DIMMED1/DIMMED2:
OFF	To change the brightness level.
	OFF:
	To dim the front display panel.
	NOTE:
	It is impossible to turn off the light of the front display completely. When “BRIGHT” or
	“DIMMED1” is selected, the brightness level will be same as “DIMMED1” after the unit is
	turned off. When “DIMMED2” or “OFF” is selected, the brightness level will be same as
	“DIMMED2” after the unit is turned off.
8 POWER SAVE	When this function is set to “ON”, you can reduce the power consumption
OFF	while the unit is turned off.
ON	NOTES:
	● During Power Save mode —
	— the front display panel will be turned off.
	— the Just Clock function ( pg. 102) does not work.
	● Power Save does not work when —
	— the unit is in the Timer mode.
	— the unit’s power is turned off after timer-recording or Instant Timer Recording.
	— the Automatic Satellite Programme Recording mode is engaged. ( pg. 65)
	— “L-2 SELECT” is set to “DECODER”, “SAT VIDEO” or “SAT S-VIDEO”. ( pg. 83)
	● It takes some time for the unit to complete initialisation after you turn on unit power,
	with “WAKE UP” blinking on the front display panel.

Page 93

April 2, 2004 11:21 am