JVC DR-M7S manual Make connections, Cautions

Filename [DR-M7EK_10Editing.fm]
DR-M7EK_01.book Page 89 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

89

Connecting To A Dolby Digital Decoder Or An Amplifier With Built-in DTS

These instructions enable you to connect your unit to a Dolby Digital decoder or an amplifier with built-in DTS.

DIGITAL OUT	DIGITAL OUT
(COAXIAL)	(OPTICAL)

To DIGITAL AUDIO input

Dolby Digital

decoder or amplifier Back of unit with built-in DTS

Coaxial cable (not provided)

Optical cable (not provided)

Note for connection: Remove the protection cap from the optical cable.

Make connections.

Connect the unit and a Dolby Digital decoder or an amplifier with built-in DTS using either an optional optical cable or an optional coaxial cable.

NOTES:

●For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 91)

●For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/ PCM”. ( pg. 91)

CAUTIONS:

●This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

When you can’t switch the audio channel of a bilingual programme

When the unit is connected with a digital audio device using an optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY DIGITAL/PCM”, it is not possible to switch the audio channel of a bilingual programme recorded on a DVD-RAM or DVD-RW (VR mode) disc. In this case, perform the following steps using the remote control to switch “DIGITAL AUDIO OUT” from “DOLBY DIGITAL/PCM” to “PCM ONLY”.

APress SET UP to access the Main Menu screen.

BPress w e to select “DVD SET UP”, then press ENTER. C Press w e to select “AUDIO OUTPUT”, then press

ENTER.

D Press rt to select “DIGITAL AUDIO OUT”, then press

ENTER.

E Press rt to select “PCM ONLY”, then press ENTER. ( pg. 91)

F Press SET UP to complete the setting.

G Press AUDIO to select the desired audio channel. ( pg. 36, “Audio Channel Selection”)

Page 89

April 2, 2004 11:21 am