JVC DR-M7S Video Plus+ System Setup, Guide Program Number Set, Enter the Guide Program number

Filename [DR-M7EK_11Subsidiary.fm]
DR-M7EK_01.book Page 95 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

95

VIDEO Plus+® System Setup

IMPORTANT:

Normally, Auto Set Up ( pg. 21), Preset Download ( pg. 23) or Auto Channel Set ( pg. 96) sets the Guide Program numbers automatically. You need to set the Guide Program numbers manually only in the following cases.

●When timer-programming with the VIDEO Plus+ system, the channel position, where the station you wish to record is received on your unit, is not selected,

OR

when you add a channel after Auto Set Up, Preset Download or Auto Channel Set has taken place,

—Set the Guide Program number for that station manually.

●When you wish to timer-record a satellite programme with the VIDEO Plus+ system,

—Set the Guide Program numbers for all satellite broadcasts received on your satellite receiver.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

Guide Program Number Set
	D Enter the receiving channel position number.
A Access the Main Menu screen.	A Press rt to select “TV PROGRAMME”, then press
	ENTER.
Press SET UP.	B Press rt to select the number of the unit’s channel
	position on which the Guide Program number’s
	broadcast is received by the unit or the satellite
B Access the “SAT/GUIDE PR” screen.
	receiver. Then press ENTER.
A Press w e to select	● Pressing AUX changes “TV PROGRAMME” to “SAT”.
	● To timer-record a satellite programme with the VIDEO Plus+
“INITIAL SET UP”, then	system, you need to install an optional Satellite Controller and
press ENTER.	perform the procedure described in “Satellite Receiver Control
B Press w e to select “SAT/	Setting” ( pg. 28).
GUIDE PR”, then press	● Repeat steps C and D as necessary.
ENTER.
	E Complete the setting.

C Enter the Guide Program number.

APress rt to select “GUIDE PROGRAMME”, then press ENTER.

BPress rt to select the Guide Program number for the desired station as shown in the TV listings. Then press

ENTER.

●To change the Guide Program number in 10 increments, press and hold rt.

Press SET UP.

Guide Program Number

“Guide Program (GUIDE PROGRAMME) number” refers to the assigned TV station numbers, according to broadcast area, for the VIDEO Plus+ timer recording. The Guide Program numbers can be found in most TV listings.

Page 95

April 2, 2004 11:21 am