46 | TIMER RECORDING |
VIDEO PLUS+® Timer Programming
You can programme this recorder to
With the VIDEO PLUS+ system, timer programming is greatly simplified because each TV programme has a corresponding code number which your recorder is able to recognize.
Before performing the VIDEO PLUS+ Timer Programming:●Make sure that the recorder’s
●Turn on the TV and select the AV mode.
●Slide TV/CABLE/SAT switch to the right.
?
A Turn on the recorder.
Press 1.
B Load a cassette.Insert a VHS (or
APress PROG.
BPress w e to move the arrow to “VIDEO PLUS+”, then
press OK.
●When “PROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMME” appears on the TV screen, you need to cancel some of the currently set programmes. ( pg. 50)
D Enter the PLUSCODE number.Press the number keys to enter the PLUSCODE number of a programme you wish to record.
OR
APress w r e t to move the arrow to the desired number key, then press OK.
BRepeat step A to enter all needed numbers.
●If you make a mistake and needed to delete the last entered number, press w r e tto move the arrow to “DELETE”, then press OK.
●To delete all entered numbers at the same time, press w r e t to move the arrow to “DELETE ALL”, then press OK.
E Select the recording deck, then confirm thePLUSCODE number.APress w r e t to move the arrow to “RECORD TO”, then press OK.
BPress r t to select “HDD” or “VHS”, then press OK.
CPress t to select “CONFIRM”, then press OK.
●If the number you entered is invalid, “PLUSCODE NO. ERROR CONFIRM PLUSCODE NO. THEN RETRY” appears on the TV screen. Input a valid PLUSCODE number.
●If “SET GUIDE PROG THEN RETRY” appears on the TV screen, set Guide Program Numbers ( pg. 83) manually.
F Check the programme data.The PLUSCODE number you entered and the matching
●To cancel this setting, press PROG.
IMPORTANTMake sure the channel position number you wish to record is displayed; if not, see “VIDEO PLUS+® System Setup” on page 83 and set the Guide Program number correctly.
G Set the recording speed.APress r t to move the arrow to “REC MODE”, then press OK.
BPress r t to select the desire mode, then press OK.