26 BBC1
33 BBC2
23 ITV
30 CH4
37 CH5

87

E View the Confirmation screen.

After “SCAN COMPLETED” is displayed on the TV screen for about 5 seconds, the Confirmation screen looking like the one to the right appears. The stations your

recorder located appear on a Confirmation screen — channel positions (PR),

channels (CH) and station names (ID –  pg. 91). The blueback screen and the programme currently being broadcast by the blinking station appear alternately for 8 seconds each. To view the next page, use the w r e t button on the remote control.

●The Guide Program numbers will also be set automatically during Auto Channel Set.

F Return to the normal screen.

Press MENU.

●Using the Confirmation screen, you can skip or add channel positions, enter station names and perform other operations. Refer to pages 88 – 90 for the procedures.

●Depending on reception conditions, the stations may not be stored in order, and the station names may not be stored correctly.

IMPORTANT

●In certain reception conditions, station names may not be stored correctly, and Auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly when you timer-record a TV programme using the VIDEO PLUS+ system, the recorder will record a TV programme of a different station. When programming the

timer using the VIDEO PLUS+ system, be sure to check the desired channel is selected correctly ( pg. 46, “VIDEO PLUS+® Timer Programming”).

●Your video recorder memorizes all detected stations even if

reception of some of them is poor. You can delete those stations with an unacceptable picture ( pg. 89, “Delete A Channel”).

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform tuning manually, refer to page 90.

●If you perform Auto Channel Set when the aerial cable is not connected properly, “SCAN COMPLETED –NO SIGNAL–” appears on the TV screen in step E. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.