81
ON
OFF
When this function is set to “ON”, the recorder automatically switches to LP mode to allow complete recording if there is not enough tape to record the entire programme while
Recording a programme of 210 minutes in length onto a
Approximately 150 minutes | Approximately 60 minutes |
SP mode | LP mode |
|
|
Total 210 minutes
Make sure you set this function to “ON”, before the
NOTES:
●If you have programmed the recorder to
●In order to ensure that the recording fits on the tape, this feature may leave a slight
●There may be some noise and sound disturbance at the point on the tape where the recorder switches from SP to LP mode.
●The Auto SP]LP Timer feature is not available during ITR (Instant Timer Recording), and the feature will not work properly with any tapes longer than
●If you perform timer recording with both PDC and the Auto SP]LP Timer activated, and the programme goes beyond its originally scheduled length, there may be times when the programme cannot be recorded in its entirety.
VCR SET UP 2
* The default setting is bold in the table below.
8 B.E.S.T. | You can set the B.E.S.T. (Biconditional Equalised Signal Tracking) system to “ON” or “OFF” | ||
ON | ( pg. 45). |
| |
OFF |
|
| |
|
| ||
8 PICTURE CONTROL | This feature helps you to adjust the playback picture quality according to your preference. Normally | ||
AUTO | select “AUTO”. |
| |
EDIT | AUTO: | Provides the optimised picture benefits of the B.E.S.T. Picture System. | |
SOFT | EDIT: | Minimizes picture degradation during editing (recording and playback). | |
SOFT: | Reduces image coarseness when viewing overplayed tapes containing a lot of | ||
SHARP | |||
SHARP: | noise. | ||
| Clearer, | ||
|
| ||
| NOTES: |
| |
| ● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you select | ||
| another mode. |
| |
| ● When you select “EDIT” to dub tapes, be sure to select “AUTO” after you finish dubbing the tapes. | ||
| ● When “B.E.S.T.” is “OFF”, “PICTURE CONTROL” switches automatically from “AUTO” to “NORM”. | ||
|
| ||
8 VIDEO STABILIZER | When this function is set to “ON”, you can automatically correct vertical vibration in the picture when | ||
ON | playing back unstable recordings made on another recorder. | ||
OFF | NOTES: |
| |
|
| ||
| ● When you finish viewing a tape, be sure to set this function to “OFF”. | ||
| ● Regardless of the setting, this function has no effect during recording and during special effects | ||
| playback. |
| |
| ● The | ||
| ● To watch recordings with | ||
|
|
|