66 | EDITING (cont.) |
Normal Dubbing
(from VHS to HDD)?
You can dub selected scenes from a cassette to the HDD deck, starting and stopping wherever you wish.
A Load a cassette.
Insert a cassette with the record safety tab intact.
B Prepare the VHS deck for dubbing.ASlide TV/CABLE/SAT to the right, then press
BPress VCR PR+/– to set the channel other than “DUB”.
● Set “PICTURE CONTROL” to “EDIT” ( pg. 81).
CLocate the start point.
ASearch for the point where you want to start dubbing by pressing 4, 5 or 3 then press 8.
BPress 3 a little, then press 4 to start playback.
CPress 9 to pause playback a little before the start point.
DPrepare the HDD deck for dubbing.APress HDD.
BPress VCR PR+/– to set the channel “DUB”.
CPress MODE to select recording speed.
E Start dubbing.APress
BPress HDD and 7 (7 and 4 on the remote control) to
start dubbing.
●To enter
F End dubbing.
Press 8 twice. Then press
NOTES:
●There may be a discrepancy of several seconds between where you intend editing to start, and where it actually starts.
●The superimposed indication during the operation or dubbing is not recorded.
●For HDD deck, the recording pause takes effect only when the recorder is recording on the HDD deck with the channel set to
●Dubbing copyright guarded tape is not possible.
●When you select “EDIT” to dub tapes in step B, be sure to select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”) after you finish dubbing the tapes.