JVC LPT0543-001A, SR-VS20EK setup guide Back of TV, Connector Scart, Back of Recorder

6QUICKSETUPGUIDE (cont.)

STEP

2

INSTALLATION

CONNECT VIDEO RECORDER TO TV

Place the recorder on a stable, flat surface.

Back of TV

RF Cable (provided)

TV Aerial Cable (not provided)

21-pin SCART Cable (not provided)	21-pin AV input	Aerial connector
	connector (SCART)

ANTENNA	AV1 (L-1) IN/OUT ENTREE/SORTIE
	OUT
ANTENNE	S SORTIE
IN	(DV/VHS)
ENTREE		AUDIO
		(DV/VHS)
		L
	SAT CONTROL	OUT
		SORTIE
	CONTROLEUR SAT
		R
OUT	AV2 (L-2)ENTREE/DECODEURIN/DECODER
SORTIE

Back of Recorder

Mains outlet

ATTENTION:

You can not use the recorder connected to your TV only with the RF cable. This is because the RF cable does not deliver signal from the recorder. Your TV must have a 21-pin AV input connector (SCART) to connect to the recorder.

AV CONNECTION

To connect to a TV with 21-pin AV input connector (SCART) . . .

1– Disconnect the TV aerial cable from the TV.

2– Connect the TV aerial cable to the ANTENNA IN jack on the rear panel of the recorder.

3– Connect the provided RF cable between the ANTENNA OUT jack on the rear panel of the recorder and the TV’s aerial connector.

4– Connect the provided SCART cable between the AV1 (L-1) IN/OUT socket on the rear panel of the recorder and the TV’s 21-pin AV input connector (SCART).

NOTES:

●The AV1 (L-1) IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the luminance and chrominance signals are separated). If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set "L-1 OUTPUT" to "S-VIDEO" after the connection and the initial settings are completed ( pg. 50) You can obtain high-quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)

●Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.

●For switching the TV's mode, refer to the instruction manual of your television.

●To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 7.

ATTENTION

Do NOT Plug the mains power cord into a mains outlet until all connections are completed.

Do NOT press the button on the recorder or on the remote control to turn on the recorder's power before you start the Auto Set Up procedure described on page 8.