JVC SR-VS20EK, LPT0543-001A setup guide END Audio Dubbing

1AUDIO

2

1	2	3
4	5	6	3
7	8	9	4
			4

0

1	3
2

STOP

					47
	5	ENGAGE AUDIO DUBBING
		Press A. DUB.
		● It is possible to take the original sound recorded on
		the tape in your recorder and mix it with other
		sounds from a microphone, CD player etc. To
		perform this audio dubbing with audio mixing,
		connect as in the diagram on page 46.
		● Your recorder enters the Audio Dubbing Pause mode.
		(" " blinks, " " and " " light up on the front display
		panel.)
		● To perform audio dubbing with audio mixing, press
		AUDIO on the remote control to select "HIFI L				R"
		or "L		R" at this point. When using the DV deck
		as the recording deck, also make sure that "12BIT
		MODE" is set to "SOUND1" ( pg. 35).
		* Audio dubbing with audio mixing is not possible if
			you're using a monaural audio component, or if
			you don't have an audio mixer.
	6	START DUBBING
		Engage the audio component's Play mode, then press
		PLAY to start the tape in your recorder. Audio dubbing
PAUSE		begins at this point.
		● When monitoring the audio-dubbed sound on the DV
		deck, set "12BIT MODE" to "SOUND2". ( pg. 35)
		● " " blinks and " " is displayed on the front display
		panel.
		● To stop dubbing temporarily, press PAUSE. Press
		PLAY to resume dubbing.
	7	END AUDIO DUBBING
		Press STOP to stop the tape in your recorder, and
		engage the audio component's Stop mode.

NOTES:

●Once the Audio Dubbing starts, you can not use the other deck.

●When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to hear the mixed sound (Hi-Fi + Normal soundtracks), press AUDIO on the remote control to select "HIFI NORM" (VHS deck only  pg. 34).

●Audio dubbing stops automatically when the counter reaches "0:00:00", and the recorder enters the Play mode (VHS deck only). Check the counter reading before dubbing.

●Audio dubbing is also possible using the rear panel AV1 (L-1) IN/OUT or AV2 (L-2) IN/DECODER connector. When using these connectors, make sure to select the correct input mode in step 3.

●Audio dubbing cannot be performed on a VHS/S-VHS cassette that has had its record safety tab removed, or on a Mini DV cassette that has had its erase protection switch set to "SAVE".

●When playing back an audio-dubbed tape on the VHS deck, press AUDIO on the remote control to select the soundtrack you wish to hear ( pg. 34). When playing back an audio- dubbed Mini DV tape on the DV deck, set "12BIT MODE" to "SOUND2" ( pg. 35).

●Audio dubbing is not possible using the DV IN/OUT connector.