JVC SR-VS20EK setup guide Close Confirmation Screen, Set Stations B, Station name begins Blinking

1

2

1 2 3

4 5 6

7 8 9

0

1

2

3

4

4

3

69

Set Stations (B)

Set station names other than the ones registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 66 to access the Confirmation screen and then perform steps 1 and 2 of "Set Stations (A)" on page 68 before continuing.

	SELECT STATION NAME
1	CHARACTER
	Press # until the first letter
	of the station name begins
	blinking.			PR CH ID	FINE DECODER
				06 CH45 BBC1	+/– OFF
MENU
				[5∞] : A-Z, 0-9
OK				[∞ ∞] : CURSOR +=
				: OK
				[MENU] : EXIT
	ENTER NEW CHARACTER
	Press %fi to cycle through the characters (A–Z, 0–9, –,
	*	#
	, +, (space) ) and stop when the desired character
2 is indicated, then press			to enter. Enter the remaining
	characters the same way (maximum of 4).
	After entering all characters, press OK.

●The Confirmation screen appears.

●If you make a mistake, press @ until the incorrect character begins blinking. Then enter the correct character by pressing %fi.

CLOSE CONFIRMATION

SCREEN

3 Press MENU.

NOTE:

The characters available for the station name (ID) are A–Z, 0–9,

–, *, +, (space) (maximum of 4).