Other Problems | JVC SR-VS20EK, LPT0543-001A specification

77

TIMER RECORDING

	SYMPTOM			POSSIBLE CAUSE		CORRECTIVE ACTION
5.	"‰" blinks for 10 seconds and the			● ‰ has been pressed when there are		Check the programmed data and re-
	Timer mode is disengaged.			no programs in memory, or the timer		program as necessary, then press ‰
				record information has been		again.
				programmed incorrectly.

6.	The cassette is automatically			● The end of the tape was reached		The programme may not have been
	ejected, the power shuts off and			during timer recording.		recorded in its entirety. Next time
	"‰" and "]" won’t stop blinking.					make sure you have enough time on
						the tape to record the entire
						programme.

7.	The VIDEO Plus+ system does not			● The recorder’s channel positions		Refer to "Guide Program Number Set"
	timer-record properly.			have been set incorrectly.		and re-perform the procedure
						( pg. 73).

OTHER PROBLEMS

	SYMPTOM		POSSIBLE CAUSE		CORRECTIVE ACTION
1.	Whistling or howling is heard from		● The camcorder’s microphone is too		Position the camcorder so its
	the TV during camcorder record-		close to the TV.		microphone is away from the TV.
	ing.		● The TV’s volume is too high.		Turn the TV’s volume down.

2.	When scanning channels, some of		● Those channels have been desig-		If you need the skipped channels,
	them are skipped over.		nated to be skipped.		restore them ( pg. 66).

3.	The channel cannot be changed.		● Recording is in progress.		Press PAUSE to pause the recording,
					change channels, then press PLAY to
					resume recording.

4.	Channel settings that were made		● After the manual settings were		Perform manual setting again.
	manually seem to have changed or		made, Auto Channel Set was
	disappeared.		performed.

5.	No channels are stored in the		● The TV aerial cable was not		Turn off the recorder once and connect
	recorder's memory.		connected to the recorder when		the TV aerial cable to the recorder
			Auto Set Up was performed.		properly, then turn on the recorder
					again. The recorder will try Auto Set
					Up again ( pg. 8).
			● The fully-wired 21-pin SCART cable		Turn off the recorder once and connect
			was not connected between TV and		the fully-wired 21-pin SCART cable to
			the recorder when Preset Download		the recorder properly, then turn on the
			was performed.		recorder again. Then perform Preset
					Download again ( pg. 9).

6.	The remote control won’t operate		● The remote control brand setting is		Re-set the remote control to the
	the TV or satellite receiver.		incorrect.		correct brand ( pg. 53, 54).

7.	No picture appears when you				Turn off the recorder or the con-
	connect an appliance to DV IN/				nected appliance once, then turn it
	OUT connector.				on again.

Image 77

JVC SR-VS20EK, LPT0543-001A setup guide Other Problems

Contents

SR-VS20EK Connection to the mains supply in the United Kingdom Safety Precautions Do not expose the apparatus to dripping or splashing Do not place the recorder…Do not block the recorder’s ventilation openings or holes Some Dos And Donts On The Safe Use Of Equipment Quick SET UP Guide Back of Recorder Connector ScartBack of TV RF Cable provided Aerial connector Before performing the following procedure, make sure that Step Auto SET UP Shows either the display as illustrated on Or remote control until the display panelProgress, this process will be interrupted You will need to start again. See Notes below C1If both auto channel set and auto clock set have failed Link Functions TV Auto Power OnTurn on the Recorder NexTView Link Satellite Receiver Control Setting Enter Satellite RECEIVER’S Brand Select Satellite RECEIVER’S Channel for TestingCheck Result of Test Code Playback Pause During Playback Activate HIGH-SPEED Search Time Code DV Deck Tape Position Indicator VHS Deck Recording DV Deck Select DV DeckPress SP/LP/EP Mini DV Reset Counter Engage ITR ModeSET Recording Duration Display Remaining Time Video Plus+ Timer Programming Satellite Receiver Users Timer WarningPDC Recording Enter Programme Express Timer ProgrammingStart Time Time Timer Mode SET PDC ModeReturn to Normal Screen Check, Cancel And Replace Programmes EX. Programme 1 you have just made When programmes overlap each otherProgramme 4 overlap each other on the VHS deck SP/LP/EP Super VHS S-VHS Super VHS ET S-VHS ET VHS Deck Only Recording According To Tape Type Press S-VHS ET on the recorder. You can check Engage S-VHS ET ModeAppears on the TV screen, press S-VHS ET again About 5 seconds to set it to on Access VHS Mode SET Access Main Menu ScreenPlayback/ Recording According To Tape Charac- teristics S.T. Picture System VHS Deck Only Playback RecordingOr press Record on the recorder During B.E.S.T Digital TBC/NR VHS Deck Only Playback Picture AdjustmentManual Tracking VHS Deck Only Video Stabilizer VHS Deck Only Digital 3R VHS Deck Only Activate Index Search Looking For Scene You WantSkip Over Unwanted Sections Instant ReView Activate InstantReview Soundtrack Selection VHS Deck Selecting Sound You WantDuring Playback USE 12BIT Mode Setting Audio-dubbed Mini DV Tape 1Sound Mode Selection DV Deck12BIT Mode Sound YOU Hear Soundtrack Selection DV Deck Type of Broadcast On-screen Display Being Received Receiving Nicam Stereo And Bilingual Programmes Minimizing Picture Degradation While Editing Select Picture Control SET ModeReturn to Normal Screen Picture Control VHS Deck Only Load Cassettes Tape DubbingSelect Dubbing Direction Select Dubbing Direction Normal DubbingLocate Start Point Pause Dubbing Program Editing Memory 8 programmes x 8 scenes Random Assemble Editing Engage VHS Deck to ScenesPause Press R.A.EDIT Camcorder Edit From If the camcorder has a DV OUT/IN connector Recorder Recorder If the camcorder has an S-VIDEO output connectorRecorder Player Edit To Or From Another Video Recorder Input ModeSET Recording DECK’S Start Source Player Your recorder TV Receiver AV modeRecorder Player Pin Scart Cable Not provided Another recorder Audio Dubbing SET Input ModeVHS Audio Dubbing DV Audio Dubbing END Audio Dubbing Insert Editing DV Insert Editing SP Mode OnlyLocate END Point VHS Insert Editing END Insert Editing Engage Insert EditingStart Editing Select Setting OUTPUT/INPUT SettingFor L-1 Output For L-1 Input VHS/AUDIO OUT Setting VHS F-1 Input Setting Change Remote Controls Code Remote Control FunctionsSET Remote Controls Code Display Code Control Your TV Using Additional Buttons TV Multi-Brand Remote ControlTV PR +/-,TV/VCR, TV TV Brand Name Code Brand Code Satellite Receiver Multi Brand Remote ControlOperate Satellite Receiver TV PR +/-,NUMBER keys ENABLE/DISABLE ON-SCREEN Display Access Mode SET ScreenOther Functions On-Screen Display OK or To set to on Power Save ModePower SAVE, then press Next Function Memory Auto TimerAuto SP→LP Timer VHS Deck Only Repeat Playback VHS Deck Only Resume RecordingRetake VHS Deck Only Ntsc Playback VHS Deck Only Back of TV Connecting To Satellite ReceiverSatellite Receiver Unit Back of Recorder Audio Cable not provided Mains outlet Connecting To Stereo System Digital printer Connecting To a Printer Connecting To a Video Titler Press DV or VHS for the playing deck, then press Play Enter Title Perform Auto Channel SET Tuner SetAuto Channel Set Pointer to Auto CH Procedures Screen preset positionsAfter Scan Completed Is displayed on the screen Storing Channels Manually Delete a Channel Change Station Preset PositionFine-Tuning Channels Already Stored Switch Stations Access ManualSelect Item Channel SET Screen Close Confirmation Screen +, space and stop when the desired characterSet Stations B Station name begins Blinking Station Name TV Station And ID List TV Station Channel Number Guide Just Clock Clock Set Guide Program Number Set Video Plus+ System SetupNumber What happens if the tape runs out during recording? Questions And Answers‰ remain lit on the display panel. Is there Problem? Safety tab removed Removed TroubleshootingNot been turned on Turned on Input mode is not correct Recording cannot be started Cassette with the Record Safety tab Protection switch set to RECProtection switch set to Save Protection switch to REC Load a cassette with the erase Other Problems Index Copie Pediting. pg Antenna in Connector enables connection Review Rew How To Use Remote Control LCD Provided accessories PAL-type colour signal and CcirPAL-type colour signal, 625 lines