JVC SR-VS20EK, LPT0543-001A setup guide Or remote control until the display panel

9

PRESET DOWNLOAD

SET THE TUNER CHANNELS BY DOWNLOADING FROM YOUR TV, CLOCK AND GUIDE PROGRAM NUMBERS

When you connect the recorder and your TV via fully-wired 21-pin SCART cable ( pg. 6), you can set the recorder's tuner channels by downloading preset data from your TV instead of using the Auto Set Up function ( pg. 8). After downloading is completed, the recorder sets the clock and the VIDEO Plus+ system assigned Guide Program numbers automatically.

For details, refer to the instruction manual for your TV.

ATTENTION

You can use this function only with a TV offering T-V Link, etc.*

*Compatible with TVs offering T-V Link, EasyLink, Megalogic, SMARTLINK, Q-Link, DATA LOGIC or NexTView Link via fully-wired 21-pin SCART cable. The degree of compatibility and available functions may differ by system.

Before performing the following procedure, make sure that:

the TV aerial cable is connected to the recorder and a 21-pin SCART cable is connected between your TV and the recorder.

the mains power cord is plugged into the mains outlet.

batteries have been installed in the remote control.

			1	Press	to turn on the recorder.
			2	If "Auto" appears on the display panel,
				Press %fi to select "CH – –" and press OK
				or #. Preset position on the display panel
				increases from "CH1";
				do NOT press any button on the recorder		T-V LINK
				or remote control until the display panel
				shows either the display as illustrated on		PLEASE WAIT
				page 10 or "– – :– –".
				● If "– –:– –" appears on the display panel, refer
				to page 10.
				● If you are using the on-screen display, the T-V
				LINK screen will appear. Then the GUIDE		[MENU] : EXIT
				PROG SET screen will appear during Guide
1				Program number set.
				● If you press any button on the recorder or
2
				remote control while downloading is in
1	2	3				GUIDE PROG SET
4	5	6	3	progress, this process will be interrupted and
				you will need to start again. See NOTES below.		PLEASE WAIT
7	8	9	4
			4
	0
1			3
2
						[MENU] : EXIT
NOTES:

●In areas where no TV station transmits the PDC signal, the recorder cannot perform either auto clock set or auto Guide Program number set.

●If there is a power cut, or if you press or MENU while downloading or set up is in progress, it will be interrupted; be sure to turn off the recorder power once and try again from the beginning.

●Auto clock may not function properly depending on reception conditions.

●When you perform T-V LINK function, be sure to use fully-wired 21-pin SCART cable.

●On this recorder, the characters available for station names (ID) are A–Z, 0–9, –, *, + and (space). The names of some downloaded stations may differ from those on your TV ( pg. 69).