JVC Connecting The TV And TV Antenna, INSTALLING YOUR NEW UNIT, 8Basic Connection, connector accepts:, Set AL-1OUTPUTB to:, When your TV’s SCART, The, RGB signal

INSTALLING YOUR NEW UNIT

Connecting The TV And TV Antenna

TV aerial cable

Mains outlet

				Mains power
				cord
Back of unit	To [TV ANTENNA IN]
IN
		To [L-1 INPUT/		To [AUDIO
		OUTPUT]
				OUTPUT]
To [TV	To
ANTENNA	[COMPONENT
OUT]	VIDEO OUT		21-pin SCART
	(Y/PB/PR)]		cable	Audio
			(supplied)	cable
				(not
				supplied)

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

1Make sure the package contains all of the accessories listed in AACCESSORIESB (A pg. 92).

2Place the unit on a stable, horizontal surface.3Connect the unit to a TV depending on the TV and cables you use.8Basic ConnectionTo connect to a TV with 21-pin SCART input connector ^ADisconnect the TV aerial cable from the TV.

BConnect the TV aerial cable to the [TV ANTENNA IN] connector on the rear panel of the unit.

CConnect the [TV ANTENNA OUT] connector on the rear panel of the unit and the TV’s aerial connector with the supplied RF cable.

DConnect the [L-1 INPUT/OUTPUT] connector on the rear panel of the unit and the TV’s 21-pin SCART connector with a supplied 21-pin SCART cable.

●The [L-1 INPUT/OUTPUT] connector accepts and delivers either a composite signal (regular video signal), Y/C signal or RGB signal.

●Set your TV to the VIDEO, Y/C, or RGB mode according to the type of your TV’s SCART connector.

8Component Video ConnectionTo connect to TV’s component video input connectors ^APerform steps A - C of ABasic ConnectionB.

BConnect the unit’s [COMPONENT VIDEO OUT (Y/PB/PR)] connectors to the TV’s component video input connectors.

CConnect the unit’s [AUDIO OUTPUT] connectors to the TV’s AUDIO input connectors.

●You can obtain high-quality component video pictures.

●By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to AScan Mode SetB (A pg. 77).

NOTES:

RF cable (supplied)

Component video cable (not supplied)

TV

●Select an appropriate option of AL-1 OUTPUTB as follows (A pg. 69):

When your TV’s SCART	Set AL-1 OUTPUTB to:
connector accepts:
Composite signals	ASCART VIDEOB
Y/C signal (separated

To 75 ohm terminal

It’s essential that your unit be properly connected.

ATTENTION:

●Your TV must have a 21-pin AV input connector (SCART) for the basic connection to the unit.

●Connect the AC plug only after all connections to the TV has been completed.

luminance (brightness) and	ASCART S-VIDEOB
chrominance (colour) signals)
RGB signal	ASCART RGBB
Component video signal	ACOMPONENTB

When the setting selected is not in accordance with the TV connected and depending on the type of appliance connected to the unit, the correct picture will not appear.

●If you possess a satellite receiver, refer to AConnecting To A Satellite ReceiverB as well. (A pg. 71)

●Connecting the FM and AM antennas (A pg. 12)●Connecting the satellite speakers (A pg. 14)●Connecting the powered subwoofer (A pg. 16)●Connecting the power cord (A pg. 16)

11