JVC Setting The Crossover Frequency, Setting The Midnight Mode, 80Hz, Press, Press, 100Hz, 120Hz, 150Hz, 200Hz, NIGHT :, NIGHT :, 1Press SETTING, 1Press SETTING

INITIAL SETTINGS

Setting The Crossover Frequency

By setting the crossover frequency, frequencies lower than the frequency being set is output from the subwoofer.

1Press SETTING.

The item of the setting performed most recently is displayed on the front display panel.

2Press F or G to display ACROSS :B on the front display panel.3Press D or E to select the frequency.

Each time you press D or E, the display changes as follows: 80HzN100HzN120HzN150HzN200HzN (back to the beginning)

Select one of the crossover frequency according to size of the connected speaker.

Setting The Midnight Mode

You can enjoy powerful sounds at night by setting the midnight mode.

1Press SETTING.

The item of the setting performed most recently is displayed on the front display panel.

2Press F or G to display ANIGHT :B on the front display panel.3Press D or E to select the mode.

Each time you press D or E, the display changes as follows: NIGHT : 1NNIGHT : 2NNIGHT : OFFN (back to the beginning)

Select one of the following modes.

80Hz

Select this when using cone speaker that is about 12 cm.

NIGHT : 1

Select this when you want to reduce the dynamic range slightly.

100Hz

Select this when using cone speaker that is about 10 cm.

NIGHT : 2

Select this when you want to maximise the compression effect. (Ideal for midnight)

Select this when playing back using full

120Hz150Hz200Hz

Select this when using cone speaker that is about 8 cm.Select this when using cone speaker that is about 6 cm. (Default)Select this when using cone speaker that is about 5 cm.

NIGHT : OFF dynamic range. (Midnight mode not activated) (Default)

24