INITIAL SETTINGS

Speaker Set

To obtain superior sound effects, you need to perform the speaker and subwoofer setting after all connections have been completed.

●Turn on the unit.

●Set the remote control selector switch to AUDIO.

●Press DVD on the remote control.

DVD

1

2

3

 

4

5

6

AUDIO

 

 

 

TV

7

8

9

SAT

 

0

 

 

SETTING

VOL

Selection Keys

(FGDE)

ENTER

SMART S.SET UP

Smart Surround Setup

The distance from the listening position to the speakers is one of the important elements to obtain the best possible sound effects. By using Smart Surround Setup, the following are automatically calculated by one simple action^clapping hands.

●Speaker distance (with comparison to the nearest speaker)●Speaker output level (except the subwoofer)1Take position from where you listen to the sound.● Make sure the speaker cables are securely connected.

2Press and hold SMART S.SET UP until ASETTING UPB blinks on the front display panel.

L

 

 

 

R SW

 

 

 

 

 

 

 

PL

3After confirming that ASETTING UPB stops blinking, clap your hand over your head once while ASETTING UPB still remains lit.

●The unit starts detecting the level of the sound coming through each speakers (except the subwoofer).

NOTES:

●In order to set the speaker information effectively using the Smart Surround Setup, the AC plug of all devices, which are potential noise sources, connected to the unit or subwoofer should be removed.

●Before starting Smart Surround Setup, set the speaker information correctly with respect to each speaker except for the subwoofer.

●When the setting is made using Smart Surround Setup, the speaker distance and output level you have set before will be invalid.

●If you have turned off the front display panel, cancel Dimmer. Otherwise, you cannot see the information on the front display panel during Smart Surround Setup.

●Smart Surround Setup may not be properly performed if the clapping sound is blocked.

●When you change the speakers, perform the procedures from step 1 again.When the clapping sound is detected successfully,

ASUCCESSFULB appears on the front display panel, and the values set are shown as follows.

Example:AB C D

L C R

RS LS
AStandard channel (the nearest speaker).

This speaker position now works as the reference position (0 m) and the distance of the other speakers is shown by the difference with this reference speaker position.

BL: Left front speakerR: Right front speakerC: Centre speakerLS: Left surround speakerRS: Right surround speakerCDifference of each speaker position in distance (m)DOutput level (-6 dB – +6 dB) of each speakerWhen the clapping sound is not detected correctly,

ASETTING UPB appears again after one of the following messages appears. In this case, repeat step 3.

SILENT:●The unit detects sound from only the left and right front speakers.

●The unit detects no sound from the front speakers and detects sound from at least one of the other speakers.

SILENT-ALL:●The unit did not detect any sound from any speakers for about 12 seconds.FAILED:●The unit cannot detect sound from the left or right front speaker.When 3 consecutive detections failed,MANUAL:

●Smart Surround Setup ends after the message is displayed. Perform ASetting The Speaker DistanceB (A pg. 23).

22