TROUBLESHOOTING

Timer Recording

Timer programming cannot be made.Date and time is not correct.] Set date and time correctly. (A pg. 19, 82)Timer recording is in progress.

] Timer programming can’t be performed while a timer recording is in progress. Wait until it finishes.

Timer programming recording does not start.

Date and time is not correct.

] Set date and time correctly. (A pg. 19, 82)

SHOWVIEW Timer Programming cannot be made.

Date and time is not correct.

] Set date and time correctly. (A pg. 19, 82)

The channel position does not correspond to that in thereceiving area.] Set the correct channel position for the receiving broadcast. (A pg. 18, 78)The SHOWVIEW system does not timer record properly.The unit’s channel positions have been set incorrectly.

] Refer to AGuide Programme Number SetB (A pg. 78) and re- perform the procedure.

Automatic Satellite Programme Recording does not start.

The satellite receiver is not connected properly to this unit. ] Connect the satellite receiver to the unit’s [L-2 INPUT/

DECODER] connector properly. (A pg. 54)On the front display panel, A- - : - -Bappears.Power failure occurred.] Set date and time correctly. (A pg. 82)The disc space does not increase when recorded titles are cleared.The PC’s data recorded on a DVD-RAM drive cannot be cleared on this unit.

] Format the disc. (When the disc is soiled, wipe the disc with a soft dry cloth before formatting.) (A pg. 6, 83)

APROGRAMME FULLB appears on the TV screen during timer programming.

All 8 programmes have already been timer programmed. ] Clear unnecessary programmes on the unit, then try timer

programming again.

Audio

No sound from speakers.Speaker signal cables are not connected.] Check the speaker wiring, then reconnect if necessary.

An incorrect input mode (analogue or digital) is selected. ] Select the correct input mode (analogue or digital).

TV DIRECT mode is activated.

] The subwoofer turns off automatically once the TV DIRECT mode is set, thus there is no sound output from the speakers. Please make use of your TV’s speakers.

The system cable is not connected. ] Connect the system cable.Hissing or buzzing sound during FM reception.Incoming signal is too weak.] Connect an outdoor FM antenna or contact your dealer.

The broadcast station is too far away. ] Select another broadcast station.

Noise during FM/AM reception.The wrong antenna is being used.] Check with your dealer to ensure you have the correct antenna.Antennas are not connected properly. ] Check the connections.Ignition noise from automobiles.] Move the antenna further away from automobile traffic.ADSP NGB appears on the front display panel.

The built-in processor is not functioning properly. ] Press A on the front panel to turn off the unit.

Remove the power cord and contact your dealer.

87