EDITING
Edit From A Camcorder
You can use a camcorder as the source player and your unit as the recording deck.
AIf the camcorder has noRecorder
To [VIDEO/AUDIO (L(MONO)/R)] input
Audio/video cable (not supplied)
Player
AUDIO/VIDEO OUT
BIf the camcorder has anRecorder
To | To [AUDIO] |
input | input |
Audio cable | |
(not supplied) | (not |
| supplied) |
| |
Player |
|
AUDIO OUT |
|
1Make connections.
AIf the camcorder has no
^connect the camcorder’s AUDIO/VIDEO OUT connectors to the unit’s [VIDEO/AUDIO (L(MONO)/R)] input connectors on the front panel.
●When using a monaural camcorder, connect its AUDIO OUT connector to the [AUDIO(L(MONO))] input connector on your unit.
BIf the camcorder has an
^connect the camcorder’s AUDIO OUT and
2Press PR +/– to select
●Set
3Press REC MODE repeatedly to set the recording mode. (A pg. 39)
4Start playback on the camcorder slightly before the actual point from where you wish to start dubbing.
5Press Ron the unit to start recording. Or while holding R, press I on the remote control. The dubbing starts.
6Upon completing dubbing, stop the unit and the camcorder.
●Stop recording on the recording deck (your unit), then stop playback on the source player (camcorder).
●All necessary cables can be obtained from your dealer.
●Refer to the camcorder’s instruction manual for operating procedure.
●The quality of the dubbed picture is poorer than that of the original.
67