Index
K
K-number, on scanner vii, 1-4
Kodak Professional Digital Print Production Software (DP2) 1-3, D-1, D-22
Kodak Professional HR 500 TWAIN Data Source 1-3
L
lamp
replacing 4-2to 4-3
turning on and off A-10, D-18lamp timer, resetting to zero A-10lamp-and-filter-access door 2-8, 4-2latch release screw 1-4
lens, cleaning 4-1light bar D-12
cleaning 4-2
loading and threading film on the Long Roll Accessory D-16to D-18
location of scanner (specifications) C-1Long Roll Accessory D-1to D-42
attaching to scanner D-8to D-10calibrating sensor offsets D-23to D-30fast forward or rewind speed D-1, D-29initializing sensors D-38to D-40installing accessory on scanner D-5to D-12installing software D-2to D-4
loading and threading film D-16to D-18maintaining D-34to D-37
parts shipped with D-5punch sensors D-14removing from scanner D-13
setting punch reader height D-14to D-22setting trigger points D-31to D-33splicing and editing guidelines D-42table of scan area values D-41threading diagram D-17
M
mag/focus tab (SAM) A-5to A-6magnification, setting 2-8, 3-4, A-5maintaining the scanner 4-1to 4-6, D-34to D-37
cleaning procedures 4-1to 4-2
Long Roll Accessory maintenance D-35to D-37replacement procedures 4-2to 4-6
balance filters 4-4to 4-5IR filter 4-5to 4-6scanner lamp 4-2to 4-3
Mechanical Hazard symbol vii miscellaneous tab (SAM) A-10
N
negative or mounted slide, inserting in the scanner 2-10negative or positive balancing filter, setting 2-8to 2-9
O
operating the scanner 2-8to 2-13focusing 2-13
inserting a negative or mounted slide in the scanner 2-10
placing the film holder in the scanner 2-12preparing an uncarded negative
or a mounted slide 2-11scanning a single frame 2-13selecting negative or positive balancing
filter 2-8to 2-9
setting the magnification and calibrating the scanner 2-8
setting the scan parameters 2-8operations tabs (SAM)
backup 3-3, A-2, A-11calibrate/image processing A-7to A-8capture A-8to A-9
mag/focus A-5to A-6miscellaneous A-10
ordering information B-1to B-2accessories B-1supplies B-1
P
parts shipped with Long Roll Accessory D-5phone numbers
service agreement information viii service and support vii
power consumption and thermal load of scanner C-1power switch 1-4, 2-7
powering up the scanner and the host computer 2-7punch readers on the Long Roll Accessory
cleaning D-35
setting height D-14to D-22
R
readers, punch. See punch readers rebooting the scanner A-10regulatory information v
removing the Long Roll Accessory from the scanner D-13replacement procedures 4-2to 4-6
rollers on the Long Roll Accessory, cleaning D-36to D-37
S
SAM. see Service and Assembly Module scan area values
for cut-gate film holders 3-7
for the Long Roll Accessory D-41scan area, setting, in SAM 3-6to 3-7,A-9scan parameters, setting 2-8
scan, checking 3-9to 3-10scanner attributes A-10
