Kodak 6B7198 Installing the Software for the Long Roll Accessory

Using the Long Roll Accessory

D-2 May 2002

Installing the Software for the Long Roll Accessory

1. With the PC powered off, power on the scanner.

2. Wait for the series of 3 beeps to sound at the scanner (or for the lamp to

illuminate).

You must have version 3.0 or higher of SAM (Service and Assembly Module)

diagnostic software installed on the host computer and version 3.0 or higher o f

firmware on your scanner.

1. Go to:

http://www.kodak.com/global/en/service/software/hr500/navigation.shtml

2. If the version numbers for either the SAM diagnostic software or firmware are

higher than what is now installed on your scanner, follow the instructions on

the Web site to download the newer versions of SAM and the HR 500

firmware.

3. Follow the installation instructions on the Web site.