Using the Long Roll Accessory
Removing the Long Roll Accessory from the Scanner
It may be necessary to remove the Long Roll Accessory from the scanner.
CAUTION: Make sure the scanner is powered OFF.
To remove the Long Roll Accessory, reverse the installation procedure (see pages
1.Remove the aperture plate from the Long Roll Accessory. See Latching and Unlatching the Gate Actuator on page
2.Power off the scanner.
CAUTION: When removing the mounting screws in the next step, use care
to avoid dropping the screws inside the scanner.
3.Loosen and remove the 3 mounting screws.
CAUTION: Avoid hitting the light bar and the safety switch.
4.Remove and lift the Long Roll Accessory from the scanner.
5.Place the Long Roll Accessory on a flat surface.
May 2002 |
