Connecting and Operating the Scanner

Operating the Scanner

Setting the Magnification and Calibrating the

Scanner

Use your host computer’s scanner software to do this procedure.

NOTE: The terminology used in your scanner software may differ from that used in this document. Refer to the software manual’s instructions for performing specific operations such as calibrating the scanner and setting the magnification.

With the empty film holder (70MM-CAL for HR 500 Plus and 4 x 5 for

HR Universal) in place in the scanner:

1.Set the magnification to the desired level.

2.Calibrate the scanner.

Setting the Scan Parameters

Using the software installed on your host computer, set the scan parameters, such as the area to be scanned and the file that will contain the scanned image.

Selecting the Negative or Positive Balancing Filter

lamp-and-filter- access door

lift door open from here

P192_0016HC

1. Lift open the lamp-and-filter-access door.

2-8

May 2002

Page 26
Image 26
Kodak 6B7198 manual Operating the Scanner, Setting the Magnification and Calibrating Scanner, Setting the Scan Parameters