Using the Long Roll Accessory

Loading and Threading Film

IMPORTANT: Careful handling of film is extremely important. Before loading film, clean the film with Super Film Cleaner or an equivalent cleaner that has ionized air and particle transfer rollers (PTR).

Use canned air to clean the punch readers before threading film.

Before loading film, make sure you have at least 2 feet (.6 meters) of leader at each end of the roll.

CAUTION: In the steps below, be sure you determine and use the correct orientation of the flange. Incorrect setup will result in film tracking problems and loose takeups.

1.Determine the orientation of the flange for the reel or core you selected for loading:

A flange in the upright position is for thin reels

A flipped flange is for film on cores

No flanges are needed for thick reels

THIS SIDE UP FOR THIN REEL

REMOVE FOR THICK REEL

or

flange

THIS SIDE UP FOR CORE ONLY

REMOVE FOR THICK REEL

spindle

P192_1549GCA

P192_1549GC

2.If you are using either thin reels or core only, install the flanges on the spindles with the appropriate side up.

D-16

May 2002

Page 80
Image 80
Kodak 6B7198 manual Loading and Threading Film