Appendix C Scanner Specifications

Appendix C: Scanner Specifications

AC Power Requirements	1,750 watts peak

AC Frequency	50 or 60 Hz

AC Phase	Single

Operating Environment	Room temperature:	65 to 80° F (18 to 27° C)
	Relative humidity:	20 to 70%
	Ambient light:	less than 1000 lux; no exposure to direct lighting
	Altitude:	7000 feet (2134 m) maximum

Dimensions and Weight	Height:	15 in. (38,1 cm)
	Width:	24 in. (61 cm)
	Depth:	30 in. (76,2 cm)
	Weight:	120 lbs (54,5 kg)
	Footprint:	5 square feet

Operating and Service	Rear:	1.5 feet (45,7 cm) for operation,
Clearances		3 feet (91,4 cm) for service
	Sides:	2 feet (60 cm) for operation and service
	Front:	4 feet (122,9 cm) for operation and service

Scanner Location	The scanner location relative to the host workstation is limited by the SCSI
	interface cable length; if you are using a cable stocked by Kodak, this
	distance is 2 meters or less. Longer cables are not supported for use with
	the scanner. The scanner must be the only SCSI device attached to the
	host computer.
	The scanner should be located on a table that:
	• is stable
	• can support approximately 120 lbs (54,5 kg)
	• is at least 30 in. (76,2 cm) long x 30 in. (76,2 cm) wide

Power Consumption	Power Consumption: 425 watts maximum; 400 watts typical
and Thermal Load	Thermal Load:		1325 BTU operating; 1230 BTU standby

AC Voltage and Current	100 V AC/50 Hz		4.2 amps operating;	3.9 amps standby
Draw	100 V AC/60 Hz		4.1 amps operating;	3.85 amps standby
	120 V AC/50 Hz		3.5 amps operating;	3.2 amps standby
	200 V AC/60 Hz		2.0 amps operating;	1.9 amps standby
	200 V AC/50 Hz		2.0 amps operating;	1.85 amps standby
	230 V AC/60 Hz		1.8 amps operating;	1.7 amps standby
	250 V AC/50 Hz		1.75 amps operating;	1.65 amps standby

C-1