Kramer Electronics VP-725NA user manual Geometry Screen Setting Function Default

7.1.4The Geometry Screen

Figure 20 defines the Geometry screen, allowing the user flexibility in positioning his projector relative to the screening surface.

Figure 20: Geometry Screen

Geometry Screen

Setting Function

Default

Application	Select the output application: Keystone, Anyplace or	Keystone
	Rotation
Location	Select the location of the display: Front, Ceiling, Rear or	Front
	Rear ceiling
Horizontal	Adjust the horizontal keystone: -40 to 40	0
Keystone	If the projector is located at an angle to the left or right of the
	screen
Vertical Keystone	Adjust the vertical keystone: -30 to 30	0
	If the projector is located at an angle above or below the screen
Diagonal	Move the location of each corner of the display separately,	Top Left
Projection	horizontally and vertically: Top Left, Top Right, Bottom Left,
	Bottom Right or Reset (to reset diagonal projections
	settings)
Pincushion/Barrel	Adjust the pincushion or barrel appearance of the screen: -	0
	20 to 20
	For projection onto curved surfaces
Rotation	Rotate the display clockwise or counterclockwise (in 1°	0
	increments): -180 to 180
Reset all	Resets the geometry settings to their default values

Available settings for each application are listed here:

Application

Available Settings

	Keystone	Location, horizontal keystone, vertical keystone, pincushion/barrel and
		Reset all
	Anyplace	Location, Diagonal Projection and Reset all
	Rotation	Location, pincushion/barrel, Rotation and Reset all
38		VP-725NA - Configuring and Controlling the VP-725NA