
Chapter 3 IGP/PGL Emulation
Do FF at TOF
Determines whether the printer, with media already set at the TOF
•Enable. The printer will advance media from the present TOF position to the next TOF position upon receipt of a FF command, causing a blank form.
•Disable. The printer will not advance media from the present TOF position to the next TOF position upon receipt of a FF command.
IGP 100 Compatibility
This parameter forces the output to correspond with
Ignore Character
Ignore Mode
This parameter instructs the PGL to ignore the character selected under the Select Character menu.
•Disable. The PGL does not ignore any characters.
•Enable. The PGL ignores the character specified in the Select Character menu.
Select Character
Instructs the PGL which decimal character
Error Report
Sets the error reporting capability on the printer for PGL forms.
•On. Null error boundry checking is reported (printed). Any element that cannot fit on the current page is reported (printed) as an error message.
•Debug Mode. Each line of the CREATE form will be printed along with an error message if one occurred. It has the same functionaility as when a slash was entered in the command before the CREATE form name.
•Fault. The printer will halt if an IGP/PGL error occurs. When “Fault” is selected, the IGP/PGL error will be printed and the message “IGP/PGL Error” will be displayed on the front panel, followed by the printer going offline.
•Off. No label boundry checking takes place. Graphics elements such as alpha, line, barcodes etc. will be printed and clipped if they exceed the page boundaries.
110