Printronix T4204 manual LinePrinter Plus P-Series Emulation, Control Code, Define CR Code

Chapter 3 LinePrinter Plus Emulation

LinePrinter Plus P-Series Emulation

Printer

Protocol

(from page 125)

P-Series

Control Code

06

6.0LPI

8.0LPI*

10.3LPI

Control Code

08

Elongated* Backspace

Define CR	Auto LF
Code
CR = CR*	Disable*
CR = CR + LF	Enable

Overstrike

Enable*

Disable

* = Factory Default

Define LF

Code

LF = CR + LF*

LF = LF

Select SFCC

1*

(0-7F hex)

EVFU Select	Alt. Set 80-9F	Character Set	SFCC d	PSeries
			Command	Dbl High
Enable*	Control Code*	(see page 135)	Even dot plot*	Normal *
Disable	Printable		Double high	P3/4/6/9 Compat

FFValid at

TOF

Enable*

Disable

Control Code 06

Control Code 06 defines the function of ASCII code hex 06 (ACK). You can select an alternate line spacing of 6, 8 or 10.3 LPI.

Control Code 08

Control Code 08 defines the function of ASCII code hex 08 (BS). You can define the code to output an elongated character or a backspace.

Define CR Code

This option controls the action of the printer when it receives a Carriage Return code (hex 0D) from the host computer. If this feature is enabled, each time the printer receives a Carriage Return, it inserts an additional Line Feed code (hex 0A) into the data stream. Do not use this feature if the host computer sends Line Feeds to the printer.

•CR = CR. Does not insert an extra Line Feed after each Carriage Return.

•CR = CR + LF. Inserts an extra Line Feed after each Carriage Return. The next print position will be print position 1 of the next line.

132