Chapter 3 LinePrinter Plus Emulation

Overstrike

Overstrike determines the action required when a line is printed over a previous line because a carriage return was received without a line feed.

Enable. Prints the second line on top of the first line.

Disable. Replaces the characters from the first line with the second line.

Define LF Code

LF = LF. Does not perform an automatic carriage return when a line feed command is received. The next print position will be the current print position of the next line.

LF = CR + LF. Forces an automatic carriage return with each line feed command received. The next print position is position 1 of the next line.

Printer Select

Disable. Ignores the ASCII DC1 and DC3 control codes.

Enable. Disables the printer when a DC1 control code is received, and enables the printer when a DC3 control code is received.

Alternate Set 80-9F

Control Code. Interprets data in the range of hex 80 through hex 9F as a control code.

Printable. Prints data in the range of hex 80 through hex 9F.

Character Set

Specifies a character set as shown in the page 141. To use one of these sets, choose the desired group heading (such as European Sets) and press ENTER. Then choose the desired set within that group (such as Roman 8) and press ENTER. Both the group and the desired set will be starred to indicate your selection. Character sets are shown in detail in the Character Sets Reference Manual.

SFCC d Command

Even dot plot. This option interprets Speed Command as even dot plot.

Double high. This option interprets Speed Command as double high. Select this option for backward compatibility.

140

Page 140
Image 140
Printronix T4204 manual Printer Select, Alternate Set 80-9F