Printronix T4204 manual Framing Error, GAP not, Label Present

Fault Messages

Table 13. LCD Message Troubleshooting (continued)

	Can
Displayed Message	User	Explanation	Solution
	Correct?
FILE SYSTEM FULL	Yes	Insufficient Flash memory	Contact your authorized service
Add Flash		available to store file.	representative.
FRAMING ERROR	Yes	Serial framing error.	Check your serial host interface
		(serial interface)	parameter settings. If
			necessary, change them so
			they match the settings of the
			attached host.
GAP NOT	Yes	Printer is set for	1. Check to see that the media
DETECTED		Transmissive or	installed matches the media
Check Media		Reflective sensing, but a	sensor selected in the Config.
		gap, notch, or stripe is not	menu.
		being detected.	2. Clean the sensor assembly
			and paper path.
			3. Perform the Run Calibrate
			procedure described in this
			manual to improve sensors
			ability to detect the media in
		Trans Value is set too low	use.
			4. Manually enter a new Trans
		or Refl Value is set to
			of Refl value in the Calibrate
		high.
			submenu.
LABEL PRESENT	Yes	1. This is the normal	1. Remove the label from the
Remove Label (see		message when Peel-off	front of the printer to allow the
note)		or Tear-off Media	next label to print.
		Handling has been	2. Change the Media Handling
		selected.
			selection to the correct
		2. Label detected at front	option.
		of the printer by the	3. Select Tear-off Strip or
		Label Taken Sensor.
			Continuous to prevent the
		Label Taken Sensor
			printer from stopping for label
		gate is in the down, or
			removal after each label is
		enabled, position.
			printed.
		3. Incorrect media
		handling method is
		selected.

197