Chapter 3 Loading Flash Memory
7.Connect a parallel data cable to the LPT1 port or a serial data cable to the COM1 port of an
NOTE: You can connect the cable to the LPT2 port if the LPT1 port is already in use. The load commands are different if you use this port, as described in the note after step 26.
8.Connect the data cable to the appropriate I/O port of the printer.
9.Plug the AC power cord into the printer.
10.Power on the computer.
11.Create a directory on your computer hard drive where you will store the recombined files from the emulation diskettes by typing the following at the DOS prompt:
MD DOWNLOAD<return>
12.Make the newly created directory the “active” directory by typing the following at the DOS prompt:
CD DOWNLOAD<return>
13.Insert the last diskette in the series (e.g., 2 of 2, 3 of 3, etc.) into diskette drive A (or B) of the computer.
14.Get the name of the compressed file on the diskette by typing the following at the DOS prompt:
DIR A:<return> (If the diskette is in drive B, type DIR B:<return>) The compressed file on the diskette takes the form FILENAME.ZIP, where the filename is a six digit number (e.g., 123456.zip).
15.At the DOS prompt type:
A:\PKUNZIP A:\FILENAME (Replace A: with B: if you are using the B dirve), where FILENAME is the six digit number you noted in the previous step.
16.The PKUNZIP®program will execute, and the following message will appear on the computer screen:
Insert disk #1 - Press a key when ready
17.Remove the diskette in the disk drive and insert the diskette labeled Disk 1 of 2 (or 1 of 3, etc.)
18.Press the <return> key. After the file is decompressed to the hard drive, the following message will appear on the computer screen:
Insert disk #2 - Press a key when ready
19.Remove the diskette in the disk drive and insert the diskette labeled Disk 2 of 2 (or 2 of 3, etc.)
168
